You can be sure of the fact that if your car has been damaged due to vandalism or an accident, the panel beating method is the best way to repair it. Many people make the assumption that the term literally means hammering the damaged parts of the car with a hammer. However, the truth is that there is a lot more to the process than just this aspect. After all, not only are the parts damaged, but badly bent out of shape as well. For people who are just starting out, it can be a bit hard to get familiar with the entire process at once.
Having said that, whether you hire the best car spray painter in Melbourne out there or anyone else, the overall message is clear – one needs to be a lot more aware of the process of panel beating and all the aspects it consists of. Only then should you go about the process of hiring a respectable and professional service to get the job done. Here are the four vital steps:-
- Metal stretching: This is the first step of putting the metal back into shape and fixing the dent properly. In actual terms, it does not have anything to do with stretching. Once the metal of the dented area has been heated with a blow torch, it will be hammered slowly using a dolly and a shrinking hammer. This will enable you to stretch the metal back to shape. This is the first vital step that you will need to oversee.
- Welding: This is done when two pieces of metal need to be joined together. Being the second process and a localised one at that, either arc welding or an oxyacetylene flame is used.
- Putty fillers: This is done primarily to fill up small dents and holes on the body. Once the panel beaters are done with preparing a putty mix, they will set it on the holes as quickly as possible so that it can be shaped all through.
- Panel sanding: Once the putty has hardened to a considerable degree, the process of sanding starts. Doing this properly will guarantee a proper smoothing of the surface of your car for the following paint job that is yet to come. Wet sanding and dry sanding are two integral parts of the overall process.
At the end of the process, one must ensure that spray painting is done towards the end as that put the final curtain on the entire process of panel beating. Most of all, being such a complex process requires that you actually spend some quality time choosing the right panel beater for the job. There are simply no two ways about that fact. Once you do that, keeping the four pointers listed above in mind is essential as they will go a long way in ensuring that you know exactly what the service is doing and at what specific time.
